Our Services
Comfort Medics repairs heat pumps for homes across North Georgia. If the system is blowing cool air in heat mode, the outdoor unit is iced over, emergency heat will not kick off, or the house will not catch up on a cold morning, call (470) 360-8887. Emergency heat pump repair is available 24/7. We are based in Kingston, and we come to you.
Schedule Heat Pump Repair Call (470) 360-8887
We serve Kingston, Rome, Cartersville, Calhoun, Adairsville, Woodstock, Canton, Marietta, Acworth, Kennesaw, Smyrna, Dallas, Milton, Roswell, Jasper, Ball Ground, Ellijay and Dalton.
What a heat pump repair visit costs
Repair visits have a $125 service fee, credited toward the repair if you go ahead with it. Comfort Club members do not pay service fees. We aim for a 24-hour turnaround for most repairs. Financing for repairs is available through FTL Finance; see financing.
Symptoms that usually mean the heat pump needs service
A heat pump moves heat; it does not burn fuel. The air from the vents is often warm, not furnace-hot, and that is normal. These patterns are not:
- Cool or barely warm air while the thermostat is set to heat
- The outdoor unit packed in ice for hours, or ice that never clears after a defrost cycle
- The system running almost constantly without reaching the set point on a typical winter day
- Auxiliary or emergency heat staying on, or never coming on when the heat pump cannot keep up
- A unit that still cools when it should be heating, or will not switch seasons at all
- Short cycling, unusual noise from the outdoor unit, or a breaker that will not stay on
If you want a walkthrough of what is safe to check before we arrive, see our guide to a heat pump that is not heating. For no heat after hours, call us and see emergency HVAC service.
Defrost problems
In cool, damp weather a thin layer of frost on the outdoor coil is expected. The heat pump should run a defrost cycle on its own: the outdoor fan may stop, you may see steam, and the indoor unit may use auxiliary heat for a few minutes so the house does not go cold. That cycle should finish and leave the coil clear.
When defrost fails, the coil stays buried in ice, airflow through the fins stops, and heating capacity falls off. Common causes are a failed defrost sensor or outdoor board, a fan that is not running, low refrigerant, or airflow problems at the indoor coil. We test the defrost sequence, sensors and board, and we do not chip ice off the coil with tools, which can puncture a refrigerant tube. If the unit is a solid block of ice, turn it off and call. We will thaw and diagnose it at the house.
Reversing valve
The reversing valve is what makes a heat pump heat in winter and cool in summer. If it sticks, will not shift, or is not getting the signal to change position, the system can blow cool air when it should be heating, or stay in one mode all year. That is a diagnosis with the covers off: we confirm the valve is receiving the correct signal, check whether it is mechanically stuck, and tell you the repair price before work starts. It is not a parts-swap guess from the driveway.
Low refrigerant and leak search
A heat pump needs the correct refrigerant charge to move heat, especially as outdoor temperatures drop. A slow leak leaves the system short of charge, so heating fades, the outdoor coil ices more easily, and the compressor works harder than it should. We look for the leak, repair it when it can be repaired, and weigh in the charge to the manufacturer’s specifications. Refrigerant work is licensed work. Adding refrigerant without finding the leak is a temporary patch, and we do not treat it as the fix.
Iced coil
An iced outdoor coil can be a failed defrost cycle, or it can be a symptom of something else: low refrigerant, a dirty or blocked coil, a failed outdoor fan, or restricted airflow indoors. An iced indoor coil is a different problem, usually tied to airflow (a dirty filter, blocked returns, or a blower that is not moving enough air) and should be diagnosed before the coil is simply thawed and left to freeze again. We find which coil is icing, why it is icing, and what has to be repaired so it does not come back on the next cold, wet night.
Auxiliary heat
Electric auxiliary, or strip, heat is the backup. It should come on when the heat pump cannot keep up, during a defrost cycle, or when the thermostat is set to emergency heat. If the strips are burned out, miswired, locked out in the thermostat, or running all day because the outdoor unit has failed, the house may stay cold or the electric bill may jump. Emergency heat is meant for a short stretch or a failed outdoor unit, not as an everyday setting. We check strip operation and the thermostat’s auxiliary settings, and we repair the heat pump itself when that is what is actually wrong.
Thermostat
Heat pumps need a thermostat that is set up for a heat pump, in Heat or Auto, not Cool. A thermostat still configured for a furnace, set to emergency heat by mistake, or programmed with the wrong number of stages can leave the outdoor unit or the strips sitting idle. We check the mode, staging, and wiring against the equipment you have before we treat the outdoor unit as the problem.
Airflow
A clogged filter, closed supply registers, blocked return grilles, a dirty indoor coil, or leaky, undersized ducts starve the system of air. Low airflow cuts heating capacity, can contribute to icing, and can trip safety limits. We check the filter and the obvious restrictions on every visit, and we measure airflow and static pressure when that is what the symptoms call for. Some airflow problems are a quick filter change. Others are a duct or blower repair, and we will price that before we start.
When to repair, and when to replace
We diagnose the heat pump at the house and give you a price for the repair before work starts. When it is relevant, we will also price a new system so you can compare. A second opinion before you decide on a replacement is free. If another company recently installed a system and you want us to evaluate that install, that visit is $100.
Repair is usually the right first step when the unit is otherwise sound and the failure is a control, sensor, fan, valve, leak, or airflow problem we can fix. Replacement is worth weighing when the compressor or coil is failing, the system is mismatched to the house, or repairs keep stacking up. If a new heat pump is the better path, our heat pump installation and replacement page covers the process and warranty. We pull a permit on every replacement, run a load calculation, and haul off the old equipment. New systems include a 10-year manufacturer parts warranty on qualifying equipment (registration may be required), a 10-year labor warranty from Comfort Medics, and our lifetime craftsmanship guarantee. Details are on our HVAC warranty page.
If the problem turns out to be a gas furnace instead of a heat pump, see furnace repair.
Heat pump repair questions
Do you work after hours?
Yes. We offer 24/7 emergency service, including no-heat calls. See also our emergency HVAC page.
Is the $125 fee extra on top of the repair?
The $125 service fee is credited toward the repair if you go ahead with it. Comfort Club members do not pay service fees.
Do you repair ductless mini-splits too?
Yes. Ductless systems are heat pumps. For a new mini-split, see our mini-split installation page. For a unit that is not heating or cooling, call the same number and we will diagnose it at the house.
Schedule Heat Pump Repair
Call (470) 360-8887 or send the form and we’ll call you back to schedule.





